Ncstar ARLSG User Manual download pdf (Page 2)

mount(1) around the barrel of your firearm with the top half on top of the barrel and

the bottom half with the laser directly below the barrel. Once you have the mount

in the desired position, you can install and tighten the Barrel Mounting Screws(11).

Be sure not to over tighten the Barrel Mounting Screws(11) to avoid stripping them.

Also, be sure that the mounting location for the laser allows for proper function and

movement of all parts of the firearm.

ZEROING:

 WHEN OPERATING ANY TYPE OF FIREARM ALWAYS USE PROPER

EYE AND EAR PROTECTION. BE SURE TO USE YOUR FIREARM IN AN

AREA THAT IS PERMISABLE UNDER LOCAL, STATE, AND FEDERAL

LAW.

Begin the zeroing process by first turning your laser to the On position by either twisting

the Rear On/Off cap(4), or by depressing the Pressure Switch Pad(10). Set up a target

at the desired distance. Place your laser beam on the center of the target. Be sure to

secure the firearm so that it will not move when fired. Fire a few shots to see where the

projectiles land in relation to the laser beam. Adjust the laser to match the shot

grouping using the provided allen wrench. To perform this action, begin by removing

the Front Cap of the Laser housing(3) by twisting it counter clockwise. By examining the

face of the laser you will see that there are to small adjusting screws, one with a U

(meaning up)which is your Elevation Adjuster(6), and the other with an R (meaning

right) which is your Windage Adjuster(7) . There also reference arrows that wrap around

the adjuster screws(6 & 7) that indicate the direction to turn the screw in order move

the laser to the desired location. For instance, when you want to move the laser beam

up you can see that you must turn the “U” adjuster screw(6) clockwise. So to move the

laser beam down you must turn the “U” adjuster screw(6) counter clockwise. After

adjusting the laser beam to match the location of the shot grouping, fire a few more

shots to confirm zero. If the laser is still not zeroed then follow the same procedure

again making small adjustments until the desired level of accuracy is achieved. Using a

laser bore sighter will also make the zeroing process a little easier. Another method is to

zero the laser beam to the iron sights of the firearm if they are available. After the

zeroing process is complete, be sure to reinstall the front cap(3) to protect the laser

from damage.

1 2 3 4 5 6

No comments

Ncstar ARLSG User Manual Page 2